After long and hard deliberation with myself (I think) I finally found the best way to install the XM Antenna on the RV. My first thought was to run it out the driver window and up to the roof but I think this is much better.
The Livingroom slide has a corner where 2 flaps/seals form a small hole in which the antenna cable can lay undisturbed and should not get caught on anything when operating the slide. We did a few test runs and nothing happened.
This was also the first time wirking with “dicor” and so far I must say it worked well.. the “selfleveling caused a bit of a “snotnose” but you cant tell from standing on the ground and I am not going to any award in workplace cleanliness.
In case something does get caught and the antenna gets damaged I can replaced it easy and just slap a new magnetic one on the roof… I doubt that dicor’ed steelplate is going anywhere